How to use the flooring calculator
- Add each room and closet. Measure wall to wall. Split L-shaped rooms into two rectangles.
- Choose your flooring type and layout. The layout sets the waste allowance.
- Enter the coverage per box from the carton. Flooring boxes vary widely, from about 15 to 30 sq ft. Add the price per sq ft or per box to see the cost.
- Tick underlayment if your planks do not have it attached, and enter the coverage per roll.
- Leave trim on to estimate baseboard or quarter-round. Enter the number of doorways, because trim does not run across them.
The formula
Floor area = Σ room length × width
Area to buy = floor area × (1 + waste %)
Boxes = round up( area to buy ÷ coverage per box )
Underlayment = round up( floor area × 1.05 ÷ roll coverage )
Trim (ft) = Σ room perimeters − doorways × 3 ft
Trim pieces = round up( trim ft × 1.10 ÷ piece length ) Boxes are always rounded up, and the results show how much flooring will be left over. Keeping one unopened box is wise, because flooring lines change often.
Trim length uses the perimeter of each room minus about 3 ft per doorway. 10% is added for miters and short offcuts that cannot be reused.
Worked examples
Living room plus closet in LVP
- Living room 15 × 12 ft = 180 sq ft; closet 6 × 4 ft = 24 sq ft; total 204 sq ft.
- Straight layout, 10% waste: 224.4 sq ft.
- Boxes of 23.4 sq ft: 224.4 ÷ 23.4 = 9.6, so 10 boxes (234 sq ft).
- Quarter-round: perimeters 54 + 20 = 74 ft − 2 doorways × 3 ft = 68 ft, + 10% ÷ 8 ft = 9.4, so 10 pieces.
Buy 10 boxes and 10 pieces of trim. 30 sq ft will be left over.
Herringbone engineered wood in a 15 × 12 ft room
- 180 sq ft + 20% herringbone waste = 216 sq ft.
- Boxes of 18.6 sq ft: 216 ÷ 18.6 = 11.6, so 12 boxes.
- Underlayment rolls of 100 sq ft: 180 × 1.05 = 189 ÷ 100, so 2 rolls.
Buy 12 boxes and 2 rolls of underlayment.
Waste allowance by layout
| Layout | Waste | Notes |
|---|---|---|
| Straight / random stagger | 7–10% | Offcuts from one row start the next |
| Many small rooms, hallways, angles | 12–15% | More short offcuts that cannot be reused |
| Diagonal | 15% | Angled cuts along every wall |
| Herringbone / chevron | 15–20% | Every perimeter piece is cut; pattern planks are not interchangeable |
Assumptions and limits
- Rooms are measured wall to wall. Flooring under the toe-kick of cabinets is not included unless you add it.
- Trim assumes about 3 ft per doorway, with no trim along cabinets, tubs or stair edges. Subtract those yourself for an exact count.
- Underlayment rolls are butted, not overlapped, with 5% extra for trimming at walls.
- Carpet and sheet vinyl are sold off rolls and are not covered here. The square-yard figure is shown for reference.
Common mistakes to avoid
Using sq ft per plank instead of per box
Check that the coverage you enter is for a whole box, not one plank. It is printed on the carton and the product page.
Doubling up underlayment
Many LVP and some laminate planks have a pad attached. Adding another layer can make the click joints fail and may void the warranty.
Skipping acclimation
Wood and some laminates need to sit in the room before installation. Plan the time between delivery and install.
Buying exactly what you need
Damaged boards, bad ends and color mismatches are normal. If you have no spares, a later repair may be impossible to match.
Frequently asked questions
How many boxes of flooring do I need for 500 square feet?
With 10% waste you need 550 sq ft. At 20 sq ft per box that is 28 boxes; at 23.4 sq ft per box, 24 boxes. Always use your product's coverage.
How much extra flooring should I buy?
Usually 10% for straight installs, 15% for diagonal layouts or many small rooms, and up to 20% for herringbone. Experienced installers sometimes manage 5–7% in large, simple rooms.
Do I need underlayment for vinyl plank?
Only if the planks do not have one attached and the manufacturer calls for it. Over concrete, a vapor barrier may be required even when a pad is attached. Follow the installation guide.
Should flooring go under kitchen cabinets?
Floating floors such as laminate and LVP should not be pinned under cabinets or islands. Nail-down hardwood sometimes goes under, so that cabinets can be replaced later. Measure only where the floor will go.
How do I estimate baseboard or quarter-round?
Add up the room perimeters, subtract doorways and anything trim will not run along, then add about 10%. The calculator does this using 8 ft pieces by default.
Formulas covered by automated tests · Last reviewed · How we calculate